wear resistant coatings > BD408 slurry pipeline anti erosion wear resistant coating

BD408 slurry pipeline anti erosion wear resistant coating

BD408 desulfuration slurry pipeline flakes anti corrosion wear abrasion resistant epoxy ceramic coating

Product description:
The BD408 flakes anti corrosion abrasion resistant coatings compounded by various high performance corrosion
resistant materials,glass flake and modified toughening resin to give rise to the co-polymerization to form the interpenetrating network structure and generate the synergistic effect. In this way,
it effectively improves the corrosion resistant of polymers. It is widely used in preparation of the corrosion resistant
coating for the surface of machine parts of suffering from the corrosion under 100 degree. This product doesn’t
contain any organic solvent,and the curing has no any microcosmic pores. it can effectively avoid the medium
immersing through solvent evaporation pores to cause under-film corrosion.

Performance index:

Product Name	Color	Status	Packaging	Operation time limit (25℃)	Curing time (25℃)
BD408 flakes anti corrosion abrasion resistant epoxy coating	Grey	Paste	20kg	30 min	24 hours

Density (g/cm3)	Compressive strength (Mpa) GB1041-2008	Tensile strength (Mpa) GB6329-2009	Shear strength (Mpa) GB7124-2008	Bending strength (Mpa) GB1042-1999	Hardness （Shore D） ASTM-D-2556	Working temperature （℃）
1.2	70	31	12	57	79	-60～100

How to use:
1.Surface treatment: Sand blasting or grinding&coarsening the surface of the machine parts with angle grinder,
and then clean it with the cleaning agent to remove the dust, greasy dirt and moisture on the substrate surface,
make the surface present the clean and fresh substrate.

2.Priming: Fill up and dense the air holes, the pitted faces and the grooves on the working surface with the corrosion
resistant daub, and then make the mixing uniformly BD407 anti corrosion wear resistant epoxy coating brush coating
on the bottom layer as the undercoat

3.Coating(BD408)：After the bottom layer of BD407 corrosion resistant wear resistant coating initial curing,then make
the mixing uniformly BD408 scale anti wear corrosion resistant repair coatings scrape coating on the undercoat in one
direction and layer by layer.The next scale corrosion resistant adhesive layer cannot be scraped until the last one has
initial cured.

4.Topcoat: After the last layer of BD408 corrosion resistant coating initial curing, and then brush coating it with the
BD407 anti abrasion corrosion resistant epoxy coating as the surface layer.

5.Curing: it can be put into using to cure for 24 hours at the temperature of 25-30 degree.It can’t be cured fully,if the temperature is below 15 degree,should heat it up (bake with the iodine-tungsten lamp or heat with electric hair dryer) to the temperature of 60-80 degree,then keep this temperature for 2 hours to promote the adhesive layer curing fully.

Packaging specification:
20Kg/group,packed in a iron drum, A component: 16Kg/drum, B component: 4Kg/drum.

Transportation storage:
1.Sealed storage in the cool and dry place.The warranty period is 12 months
2.Avoid Placing it upside down, knocking against and transporting it as a non-dangerous product during transportation.

Product packaging photo of our BD408 desulfuration slurry pipeline high temperature flakes anti corrosion wear abrasion
resistant coating:

------分隔线----------------------------